Report Workspace

This expander displays the type of report selected.

This expander allows you to configure the following parameters for scheduling a report.

• Enable Schedule Report: Allows you to activate the configuration for routing the selected report to an email group or to a folder in the local memory.
• Username and Password: You have to enter the username and the password of the logged-in user to continue with the configurations.
• Schedule Interval: Allows you to select the interval for the routing of the report.
• Next schedule: Displays the date and time of the routing schedule. You can also select the scheduling date and time from this dropdown.
• Report File type: Allows you to select the format of the generated scheduled report. You can generate a report as either a PDF or EXCEL.
• E-mailing list: Allows you to select the email group to which the report will be routed.
• Report Save Location: Allows you to select the location of the folder in the local memory the report is routed to.
• Report Parameters: Allows you to configure the report parameters to be included in the scheduled report. The options include the following:
• Duration
• Interval Type
• Interval Length
• Additional Interval
• Chart Type
• Compare

NOTE:
The parameters in the Report Parameters section vary depending on the report type selected.

This expander allows you configure the following parameters of the report.

• Create Maximum, Minimum and Average Values: Select this checkbox to display the maximum, minimum and averages values in the generated report.
• Device: Allows you to add a device either by dragging-and dropping or by clicking New.
• Measurement Point: Allows you to configure the measurement points to be included in the report.
• Unit: Displays the unit of the selected measurement point.
• Factor: Allows you to enter the conversion factor for the selected measurement point.
• Converted Unit: Displays the unit of the measurement point after the conversion factor is applied.
• Sum: You can select the checkbox under this column to display the sum of the values.
• Weighing Factor: Allows you to set the weighing factor for the selected measurement point. The sum of the weighing factors for a measurement point is always one. If a weighing factor added for a measurement point is less than one, the difference of the weighing factor value is auto generated for the corresponding weighing factor.

Sankey Report: The toolbar in the Source expander of the Sankey report allows you to perform the following operations.

NOTE:
You can add a maximum of 10 measurement points to a Power Peak report.